Rockwell Automation 1557 MEDIUM VOLTAGE AC DRIVE - Manual (Page 147)

OPERATOR INTERFACE TERMINAL PV-550 REV E 7-23
1557-UM050F-EN-P – June 2013
The default value for the password is zero (0), or simply pressing the [enter] key. This value can
be changed from the ACCESS screen. Press the [F9] key. The PASSWORD CHANGE screen
shown in Figure 31 is displayed.
Enter the current password value via the data keys [0]-[9] and press the [enter] key. As in the
ACCESS screen, the entered value is shown via place holders and may be edited with the
[backspace] key.
If you entered the correct password, the screen now asks you for the new password. Type in the
new password value using the data entry keys [0]-[9] followed by the [enter] key. The screen now
asks you to verify the new password. Type in the new password again followed by the [enter] key
as shown in Figure 32.
At the end of the operation you will see a status as shown in either Figures 33, 34 or 35
depending on whether you successfully changed the password, incorrectly entered the existing
password or incorrectly verified the new password.
If you were not successful in changing the password, simply start over again by typing in the
current password value.
Figure 31 – Enter Existing Password Figure 32 – Enter the new Password
Figure 33 – Successful Password Change