Rockwell Automation 1557 MEDIUM VOLTAGE AC DRIVE - Manual (Page 161)

OPERATOR INTERFACE TERMINAL PV-550 REV E 7-37
1557-UM050F-EN-P – June 2013
Request Printouts
When the drive contains the optional printer, you can obtain hard copies of the data which you are
able to view on the terminal. The printouts are requested from the PRINTER screen. Press [F3]
while displaying the Top Level Menu.
The screen typical of Figure 63 is displayed. It shows the current status of the printer (A-B part #
80025-290-
01) and the type of reports which are available. (Refer to the “Syntest SP401 Thermal
Printer User Manual”, for information regarding the use of the printer hardware and a description
of the various reports available). Using the [cursor up] and [cursor down] keys, select the desired
report and press the [enter] key. The report will be sent to the printer.
The printer can automatically printout the alarms as they occur. This feature is selected as one of
the report formats. In the Figure 63, the "AUTO - ON" indicates that this feature is currently
enabled. To disable the feature, use the [cursor down] key to select the text and press the [enter]
key. The text will change to "AUTO - OFF" (if a printer is attached). The automatic alarm printout
feature is now disabled. Pressing the [enter] key again while selected will enable the feature.
Perform Diagnostic Trending
The diagnostic trending operation of screens allows you to capture the relationships of a number
of variables over a period of time. Within this operation you will:

Define the Variables to which the Trend Apply

Define the Trigger Condition to Begin the Trend

Define the Sampling Rate and position of the Trigger

View the results of the Trend
You will access the Diagnostic Trend operation from the Top Level Menu by pressing the [F9] key.
This results in the display of the screen shown in Figure 64.
Figure 63 – Typical Printer Screen