Rockwell Automation 1557 MEDIUM VOLTAGE AC DRIVE - Manual (Page 168)

7-44 OPERATOR INTERFACE TERMINAL PV-550 REV E
1557-UM050F-EN-P – June 2013
An existing filename can be used as a basis for the new filename by first selecting that filename.
Press the [F2] key. The filename can n
ow be edited. Refer to the section entitled “Edit Text” for
further details. When complete, pressing the [Enter] key will proceed with the operation.
Loading Programs (Firmware)
Firmware is the program which is run in the terminal to provide all the functionality described in
this manual. Firmware is loaded from the flash card in one of two ways.
a) If a terminal has a memory card inserted when it is powered up or rebooted, and that card has
a valid firmware file with the extension of .FMW, the terminal will automatically load the first
.FMW file it encounters on the card.
b) The user can select from one or more .FMW files on the card and load the selected firmware
into the terminal. This is the method which will be described here.
From the TRANSFER screen, press the [F3] key. The terminal will enter the DIRECTORY screen
from which an existing firmware filename can be selected or entered. Refer to the sections
entitled “Select a filename” and “Enter a filename”. (If nothing happens then you have not gained
the required access to modify the flash memory. Exit to the TRANSFER screen and refer to the
section entitled “Enter/Modify a Password (Access)” to gain access).
When the filename has been obtained, the TRANSFER: PROGRAM screen such as that in Figure
75 will be displayed, showing the filename, indicating the operation you are about to perform and
showing the current status of the operation.
Figure 74 – Typical File Selection