Rockwell Automation 1557 MEDIUM VOLTAGE AC DRIVE - Manual (Page 171)

OPERATOR INTERFACE TERMINAL PV-550 REV E 7-47
1557-UM050F-EN-P – June 2013
Download from Terminal
The parameters stored in the terminal are downloaded to the drive by pressing the [F3] key. A
screen similar to that shown in Figure 77
will be shown (except the operation will show “MEMORY
TO DRIVE”). To confirm the operation, press the [F8] key to proceed, or the [F9] key to abort.
Pe
rforming a “MEMORY TO DRIVE” transfer will overwrite the active parameters in the drive. It
will not affect the parameters stored within the drive‟s EEPROM.
After parameters have been downloaded you will be prompted to make the new parameters
downloaded t
o the drive permanent. Refer to section “Message Prompting” for further details.
Upload to Memory Card
The parameters are read from the drive and stored on a memory card by pressing the [F4] key.
The terminal will enter the DIRECTORY screen in which a parameter filename can be entered.
Refer to the section entitled “Enter a filename”. When the filename has been obtained, the
TRANSFER: PARAMETERS screen such as that in Figure 78 will be displayed, showing the
filename, indicating the operation you are about to perform and showing the current status of the
operation.
The screen will then ask you to confirm the operation. Press the [F8] key to proceed, or the [F9]
key to abort. An aborted transfer or one which failed may be restarted by pressing the [F4] key.
To select or enter a different filename, press the [F7] key.
Figure 77 – Transfer Stored Parameters
Figure 78 – Transfer File Parameters