Rockwell Automation 1557 MEDIUM VOLTAGE AC DRIVE - Manual (Page 173)

OPERATOR INTERFACE TERMINAL PV-550 REV E 7-49
1557-UM050F-EN-P – June 2013
Loading Language Modules
In order to use a language in the terminal, it must first be loaded into the terminal from the flash card.
From the TRANSFER screen, press the [F5] key. The terminal will enter the DIRECTORY screen
from which an existing language module filename can be selected or entered, Figure 79. Refer to
the sections entitled “Select a filename” and “Enter a filename”. (If nothing happens then you have
not gained the required access to modify the flash memory. Exit to the TRANSFER screen and
refer to the section entitled “Enter/Modify a Password (Access)” to gain access).
When the filename has been obtained, the TRANSFER: LANGUAGE screen such as that in
Figure 80 will be displayed, showing the filename, indicating the operation you are about to
perform and showing the current status of the operation.
The screen will then ask you to confirm the operation. Press the [F8] key to proceed, or the [F9]
key to abort. If an attempt to download a language module which already exists is made, the
transfer will fail.
In order to download a newer version of a language, all languages in the terminal must first be
cleared (this is a characteristic of flash memory) by pressing the [F2] key on the
TRANSFER:LANGUAGE screen. The screen as in Figure 81 will then ask you to confirm the
operation. Press the [F8] key to proceed, or the [F9] key to abort.
An aborted download or one which failed may be restarted by pressing the [F5] key. To select or
enter a different filename, press the [F7] key.
Figure 79 – Language Directory Figure 80 – Transfer Language Module
Figure 81 – Clear Languages