Rockwell Automation 1557 MEDIUM VOLTAGE AC DRIVE - Manual (Page 177)

OPERATOR INTERFACE TERMINAL PV-550 REV E 7-53
1557-UM050F-EN-P – June 2013
The value may be edited via the [cursor left] key which acts as a backspace to remove the last
digit entered. The value is accepted by pressing either the [enter] or [F7] key. The edited
segment:offset can be aborted by pressing the [delete] key. To accept the segment:offset value
entered, press the [enter] key. The screen will show the data at the entered address, as shown in
Figure 87.
Database Download
The database download operation allows the terminal to obtain the majority of the information it
requires on your command (instead of as needed). The operation is initiated from any screen by
pressing the [F10] key and the [cursor up] key at the same time.
Obtaining the entire drive database is a lengthy process. As the terminal is receiving the
database, it will display what portion of the database it is currently obtaining, and the percent
done. If the terminal is successful in obtaining the complete database, it will display a message
indicating such and wait for a key press from you. If unsuccessful, it will immediately return to the
screen from which this call was made. The download may be aborted at any time by pressing any
key on the terminal. The portion of the database already obtained will be valid. A subsequent
request to download the database, will continue from where the previous download had
terminated.
This screen will always return to the screen from which the download was requested.
Figure 87 – Data at New Address