Metrohm IC Net 2.3 - Manual (Page 120)

6 Devices
IC Net 2.3 110
E1 Start potential for sweep.
Range:
-2 ... +2 V .
E2 End potential for sweep.
Range:
-2 ... +2 V .
Rate Definition of scan rate in mV/s.
Selection:
1, 2, 5, 10, 20, 50 mV/s
Cycle mode Definition of scan cycle:
full double scan E1 ... E2 ... E1
half single scan E1 ... E2
Selection: full, half
Range Selection of measuring range:
nA 10 ... 500 nA .
µA 1 ... 200 µA .
Offset Offset of the zero point for the analog out-
put signal.
Selection:
-50 ... +50 % (in steps of 10 %)
Data rate Setting of the data acquisition rate.
Selection:
-1, 2, 5, 10 Hz
Actual
E1, E2 Display of current start and end potentials
in V.
Rate Display of current scan rate in mV/s.
Cycle mode Display of current scan cycle mode.
Range Display of current measuring range.
Offset Display of current offset.
Data rate Display of current data rate.
<Set> Send current parameters immediately to the
871 Advanced Bioscan. Parameters are not
stored in the system file (
*.smt ) as long as
the file is not saved.
<Scan Window> Opens the 871 Scan shell window.