Metrohm IC Net 2.3 - Manual (Page 82)

6 Devices
IC Net 2.3 72
The Program tab contains the two following subpages:
Program Main time program with all program
steps.
Remote configuration Possibility for creation of user-defined
remote commands.
Program
On the
Program
subpage, program steps including time, program
instruction and parameter can be entered.
First column Time at which program instruction is ap-
plied.
Entry range:
0.0 ... 999.9 min
If no time is entered, the program instruc-
tion is applied together with the last instruc-
tion with time entry.
Second column Program instruction (see below).
In addition to these predefined instructions,
user-defined remote commands can be en-
tered if activated on the
Remote configura-
tion tab.
Third column Parameter for program instruction (see be-
low).
ENABLED Enable program start (a disabled program
is not started).
Will be executed by Selection if the time program will be exe-
cuted by the
PC or the 732 unit .
<Add> Add new program instruction.
<Delete>
Delete selected program instruction.
<Verify> Test the time program (error messages are
displayed if program is wrong).