Altera ALTPLL (Phase-Locked Loop) IP Core - Manual (Page 32)

Specifying IP Core Parameters and Options (Legacy Parameter Editors)
The Quartus II software version 14.0 and previous uses a legacy version of the parameter editor for IP core
configuration and generation. Use the following steps to configure and generate an IP variation using a
legacy parameter editor.
The legacy parameter editor generates a different output file structure than the latest parameter
editor. Refer to Specifying IP Core Parameters and Options for configuration of IP cores in the Quartus
II software version 14.0a10 and later.
Figure 23: Legacy Parameter Editors
Legacy parameter
editors
Note:
1. In the IP Catalog (Tools > IP Catalog), locate and double-click the name of the IP core to customize.
The parameter editor appears.
2. Specify a top-level name and output HDL file type for your IP variation. This name identifies the IP core
variation files in your project. Click OK.
3. Specify the parameters and options for your IP variation in the parameter editor. Refer to your IP core
user guide for information about specific IP core parameters.
4. Click Finish or Generate (depending on the parameter editor version). The parameter editor generates
the files for your IP variation according to your specifications. Click Exit if prompted when generation
is complete. The parameter editor adds the top-level
.qip file to the current project automatically.
To manually add an IP variation generated with legacy parameter editor to a project, click Project >
Add/Remove Files in Project and add the IP variation
.qip file.
Note:
Files Generated for Altera IP Cores (version 14.0 and previous)
The Quartus II version 14.0 and earlier software generates the following output for your IP core.
ALTPLL (Phase-Locked Loop) IP Core User Guide Altera Corporation
Send Feedback
ug-altpll
Specifying IP Core Parameters and Options (Legacy Parameter Editors) 32
2014.08.18