ATEIS DIVA8G2 User Manual
Page 12
DIVA system
12
© 2012 ATEÏS
Voice Amplifier
o
Connect the "AIN+", "AIN-" and " from the "VOICE AMP" connect to "Channel 1"
amplifier's input.
Note: respect polarity to avoid inversion phase problem.
o
Connect the "Channel 1" amplifier"output to the "VOICE AMP" "AOUT and "AOUT-"
connectors
Note: respect polarity to avoid inversion phase problem.
Music Amplifier
o
Connect the "AIN+", "AIN-" and " from the "MUSIC AMP" connect to "Channel 1"
amplifier's input.
Note: respect polarity to avoid inversion phase problem.
o
Connect the "Channel 2" amplifier"output to the "MUSIC AMP" "AOUT and "AOUT-"
connectors.
Power Supply
o
To ensure the surveillance role, the power supply have to be secured.
Evacuation Button:
o
Connect a button between EVAC1+ and EVAC1-.
Slave add and set up
The Slave unit is for adding zones, one DIVA master unit can connect with 15 slave units. The
maximum is 128 zones per system. The Fig3-1 shows the slave button in DIVA software, press it
and you can see the pop-up window as Fig 3.2. Net ID in this table is the same with Slave's knobs
on rear panel, the monitor detects the slave units through the ID numbers.