ATEIS DIVA8G2 - Manual (Page 87)

Product Features 87
© 2012 ATEÏS
high quality directive signal pick up from the user and hence less interference from the surroundings.
Hold LED:
These LEDs Indicate which keys are selected.
Busy LED:
Show the status of zone.
Talk Indicator:
This LED light up if it is allowed to paging, on the other word, the paging request has been
acknowledged. Sometime after paging request is granted, zones under paging still can be occupied
by other sources. In such a case, the talk led still light up, but you can check busy LED to know
the situation.
Talk Key:
Push this key to request paging.
Fault LED:
To display fault status of system.
EVAC LED:
"Plug-in" make audio processor to recognize the peripheral devices.
Power LED:
This LED light up when the PPM AS is powered on.
Event Select Key:
These buttons are used to select keys, each key may link to an event for triggering actions like
paging or adjust the value of parameters.
All/Release LED:
This indicator lights up if all keys are selected.
All/Release Button:
This button is used to select or deselect all keys.
4.2.2.3 LED Indicators
Status POWER EVAC FAULT BUSY HOLD
Inserting power supply Continuous Continuous Continuous Scrolling once Scrolling once
Display firmware's version
(EX: v4.7)
Continuous Continuous Continuous
4 LEDs blink
once
7 LEDs blink
once
Lost communication with Audio
Processor
- - -
Slowly
scrolling
Slowly
scrolling
Communicate with Audio
Processor successfully
Continuous
Goes off after
seconds
Goes off after
seconds
- -
Stored in software Continuous Continuous Continuous Scrolling once Scrolling once