ATEIS DIVA8G2 - Manual (Page 76)

DIVA system 76
© 2012 ATEÏS
As a part of the DIVA8 system, The DIVA8S Slave unit complies with current standards.
DIVA8S is made of:
8 loudspeaker zones extension (A + B).
1000 W max power on each channel.
9 evacuation input contacts (with surveillance).
8 logic input contacts.
2 fault input contacts.
8 output contacts.
Front panel zone selection buttons.
1U 19”.
Linking
To connect one slave DIVA to a master simply connect the "Link Out" connector of the Master to
the "Link In" of the slave with a RJ-45 CAT5 cable and so on for the next slave unit. To pass the
audio to the slave unit, simply connect the Master "100V Link" connector to the slave "100V In"
connectors. If more than 500W of power is needed, you can add two amplifier channels per slave
unit. To synchronize the audio, simply link the 0dB output of the master to the additional amplifiers
0dB input and additional amplifier 100V output to the corresponding 100V slave input.
The schematic below shows how to perform a DIVA system with 1 master and 2 slave units using
the same amplifier.
Figure1: DIVA8M Master unit and DIVA8S Slave unit
The schematic below shows how to perform a DIVA system with two additional amplifiers.