ATEIS DIVA8G2 - Manual (Page 235)

System Functionality 235
© 2012 ATEÏS
The length of the pulse can be defined from 50 to 60000 ms.
To learn more about output relay, please read the How To Use Output Relay.
Music Source: Here you can choose the music source you want to switch on/off by zone.
Zone Selection: Here you can specify the zone(s) where the music will switch On/Off by zone.
Security Mode
In order to be compliant to standard and to save energy, DIVA has two working mode: Normal and
Security.
Normal: DIVA is supplied by the electricity network. In normal mode, any type of event could be
started.
Security: DIVA is supplied by backup batteries after a power supply failure. In security mode, only
security event could be started, Music is automatically deactivated. The purpose of the security mode
is to save energy and to increase DIVA working state under batteries.
In order to fit the event philosophy, you can force DIVA to enter the security mode with the Security
Mode event.
Be careful when using such an event, all non security event will be unavailable.
Type: Display the type of event you are creating or modifying.
Name: Here you can specify a name for the event created. Default is Event X.
Priority: Here you can adjust the priority of the event. 20 is the lowest, 0 is the highest.
Attrib.: Not accessible.
Next Event: Here you can select the event to start after the current one is finished.
Note: In order to use a Fault Input contact to trigger the security mode, the event must be link to the
corresponding fault input. To do so, please refer to the "
How To Use Logic Inputs " chapter.
Stop All Event
This event has been design to stop all events that are currently running in the system with one trigger
action.