ATEIS DIVA8G2 - Manual (Page 239)

System Functionality 239
© 2012 ATEÏS
Priority: Here you can adjust the priority of the event. 20 is the lowest, 0 is the highest. Note: be
carful when setting priority for both sources, conflict may appeared if both sources have the same
priority level.
Attrib: Here you can specify if this event is a security one or not. See How to Use Event to learn
more about the security option.
Start Impulse: Ticking this option allows user to close an output contact (Logic Output channel)
in two different manner. Static will close it until the event stop and Pulse will generate a closing
pulse whose length can be defined from 50 to 60000 ms.
Stop Impulse: This option is used to create a closing contact pulse when the event is finished.
The length of the pulse can be defined from 50 to 60000 ms.
ACK Relay: You can specify here an logic output channel that will be closed when the event is
active.
Busy Relay: Here you can specify an Logic Output Channel relay that will be closed as soon as
a higher priority event is active in one of the pre-define zones. The output relay part is discussed in
the How To Use Output Relay, please read it.
Pre-define Zone: Here you can specify in which zone music will be routed. Note: In Route Key
mode, you don't have to pre-define zones as everything is controlled from the front panel. However,
you can specify zone in Route Key mode but keep in mind that the routing will only be activated
for default music source.
OK: Will accept the current setting and close the window.
Cancel: Will annulled the current settings and close the window.