ATEIS DIVA8G2 - Manual (Page 240)

DIVA system 240
© 2012 ATEÏS
5.7.1.1 Use Music Source From Front Panel
On DIVA front panel, you have the possibility to assigned music sources to a zone (or multiple), set up
attenuation for each speaker zone (only on music). To manage music source, the music sources should
be set in "Route Key" mode, see
How To Use Music Source.
The procedure to assign a music source to a zone is the following:
Select the music source:
o Press the SELECT button to go from Source 1 to Source 2.
o Press SELECT button to go from Source 2 to no selection.
o Press SELECT button to re-select Source 1.
Select the zone(s):
o Press the zone button(s) you want to activate on Master and/or Slaves. The corresponding
white selection LED(s) should light(s) up.
Validate the routing by pressing the ROUTE button.
You can independently route music 1 and 2 in group of zones.
Zone attenuators:
In each master zone, the music level can be attenuated depending your needs. The attenuators offer
6 attenuation positions: 0, -4, -8, -12, -16, -20 dB.
Adjust the corresponding zone(s) ATTENUATOR KNOBS to the desired attenuation level.
Note: zones that are monitored cannot be attenuated to -20dB without causing monitoring
problems. At -20dB attenuation, the accuracy of the impedance circuitry reach its limit.
Note: if two music sources are used, keep in mind that attenuator will only have effect on only
one of them (music 1). Because the Voice amplifier will be used for music 2, the attenuators
won't have any effect on the sound level.
Note: Music attenuator are only available on Master DIVA unit
5.7.1.2 With Modulation Detection
The modulation detection mode allows to automatically route music sources in case of signal presence.
You can set up both source one and two in modulation detection as well as only one source.
The normal use of this option is to set up one source in permanent mode and the other one in
modulation detection (example tuner in permanent and CD player in mod.det.). Keep in mind that in that
mode, the music front panel buttons are disabled.
In order to use the modulation detection, tick the Modulation Detection option for the source you want to