ATEIS DIVA8G2 - Manual (Page 43)

Product Features 43
© 2012 ATEÏS
Integrated monitoring speaker: The DIVA integrates a front panel monitoring speaker that can
monitor different audio sources (software configuration).
Fireman Mic input:
Monitored fireman microphone input.
All Call/Cancel button:
Selects all zone in the system or reset the current zone selection.
Alert and Test message buttons:
Starts messages in manually selected zones or in pre-defined set of zones.
Music control buttons:
The "ROUTE" button validate the zone selection. "SELECT" button permit to toggle between music
source 1, 2 or none. The two music source indicators light when the corresponding source is used.
Faults and status indicators:
There are four mains status LED on the DIVA front panel:
G.Fault
System Fault
Evacuation
By-Pass Mode
Zone attenuator knobs:
Eight zone signal attenuators are available on the master DIVA8. Independent zone music level can
be set for the eight master zones.
Zone selection buttons:
Select or deselect zone for manual routing.
4.1.1.4.1 Fireman Microphone
Wiring
To connect the SHM1 fireman microphone, simply connect the SHM1 connector with the front panel
fireman microphone connector.
In case of using another microphone, use the back connector to connect the microphone, see the
picture below. Be aware that only the connection on the front panel is certified with the EN 54-16
standard and the monitor works on both of these two connections.