ATEIS DIVA8G2 - Manual (Page 129)

Product Features 129
© 2012 ATEÏS
For each amplifier channel, there is a dedicated Audio Output connector for connection of either 8
Ohm speakers, 75V speakers or 100V speakers. For the 8 Ohm connection and if you are using
more than 1 speaker, please ensure that speakers are wired in a way that the total impedance load
is between 8 Ohm and 16 Ohm. The Com point is the terminal and 8 Ohm, 75V and 100V are the
+ terminals.
Fault Contact:
The fault contact indicates an amplifier fault by an opening contact.
Channel 1/2 Outputs:
Each channel outputs a replica of the corresponding balanced audio input signal either on XLR or on
Euro-terminal block.
Channel 1/2 Inputs:
For each channel, there is an XLR balanced input and a Euro-terminal block balanced input. Each
input can be gain adjusted to suit the user’s needs. The On/Off gain switch can instantaneously
bypass the gain controller and set the channel gain amplifier to maximum.
4.3.1.4 Characteristics
Case
Dimension:
o SPA2060, SPA2120 = 483mm (W) x 305mm(D) x 88mm(H)
o SPA2240 = 483mm (W) x 420mm(D) x 88mm(H)
Weight :
o SPA2060 = 10.6 Kg
o SPA2120 = 12.3 Kg
o SPA2240 = 18.5 Kg
Color = RAL7016.
Power
Item Voltage Current Consumption Comment
AC Input 230V +/- 10% 1.2A Frequency:47Hz~63Hz
DC Output 21~28V, Typical: 24V 1A
Audio
Frequency response = 40 - 20 000 Hz
Distortion at nominal power: < 1%
Signal/noise ratio: > 90 dB
Inputs/Outputs
Power output = 100 V
Main line input = 770 mV