ATEIS DIVA8G2 - Manual (Page 224)

DIVA system 224
© 2012 ATEÏS
Attrib.: Here you can specify if this event is a security one or not and if it is an evacuation event
or not. See
Common Option to learn more about the security option.
Next Event: Here you can select the event to start after the current one is finished.
Start Impulse: Ticking this option allows user to close an output contact (Logic Output channel)
in two different manner. Static will close it until the event stop and Pulse will generate a closing
pulse whose length can be defined from 50 to 60000 ms.
Stop Impulse: This option is used to create a closing contact pulse when the event is finished.
The length of the pulse can be defined from 50 to 60000 ms.
ACK Relay: You can specify here an logic output channel that will be closed when the event is
active.
Busy Relay: Here you can specify an Logic Output Channel relay that will be closed as soon as
a higher priority event is active in one of the pre-define zones.
To learn more about output relay, please read the How To Use Output Relay.
Message: By using the drop down menu, you can select, in the list of stored message, a
message to assign to the event.
Play Mode: By ticking continuous, the message will be played until a trigger happen. You can
also specify a number of repeat time.
Conflict: You can choose between Cancel All or Coexist.
Repeat Time: If continuous not ticked, you can choose a number of time this event will be
repeated.
Pre-define Zone: Here you can specify the pre-define zone(s) where the message will be played.
Zone Selection: Here you can specify the zone(s) where the call will be played.
Note: Messages can only be seen if they are a part of the configuration. Reading the message memory
of the DIVA does not put messages in the configuration. You'll have to reverse the messages in order to
be able to use them in the configuration.
Fireman Mic Paging
A Fireman Mic Paging event can be declared in order to be used with any type of trigger.