ATEIS DIVA8G2 - Manual (Page 152)

DIVA system 152
© 2012 ATEÏS
After the devices have been connected and in order to know if your network is well configured, go to the
"Device Search" window: Tools -> Device Search and start a search.
If some DIVA master aren't visible, please check wiring and/or IP address settings. Also check your
computer network card parameter and be sure they are set in accordance to the DIVA network built.
Note: DIVA master won't be able to communicate with each other through the network. This network
only intend to offer quick configuration solution over IP.
5.2.4 Add DIVA8S slave
From DIVA software v2.0.0.1, DIVA8S unit can be added in the configuration. In order to use slave units,
follow the next procedure.
In the Master window, click on the "Slaves" button.
Once click, the following window pops up.