H3C Technologies H3C S5120 Series Switches - Manual (Page 650)

1-7
z If the timestamp starts with a *, the information is debugging information
source
This field indicates the source of the information, such as the source IP address of the log sender. This
field is optional and is displayed only when the output destination is the log host.
content
This field provides the content of the system information.
Configuring Information Center
Information Center Configuration Task List
Complete the following tasks to configure information center:
Task Remarks
Outputting System Information to the Console Optional
Outputting System Information to a Monitor Terminal Optional
Outputting System Information to a Log Host Optional
Outputting System Information to the Trap Buffer Optional
Outputting System Information to the Log Buffer Optional
Outputting System Information to the SNMP Module Optional
Outputting System Information to the Web Interface Optional
Saving System Information to a Log File Optional
Configuring Synchronous Information Output Optional
Outputting System Information to the Console
Outputting system information to the console
To do… Use the command… Remarks
Enter system view system-view —
Enable information center info-center enable
Optional
Enabled by default
Name the channel with a
specified channel number
info-center channel
channel-number name
channel-name Optional
Refer to Table 1-2 for default
channel names.
Configure the channel through
which system information can
be output to the console info-center console channel
{ channel-number |
channel-name }
Optional
By default, system information
is output to the console through
channel 0 (known as console).
Configure the output rules of
system information
info-center source
{ module-name | default }
channel { channel-number |
channel-name } [ debug { level
severity | state state } * | log
Optional
Refer to Default Output Rules
of System .