Modifying command level, Displaying and maintaining basic configurations – H3C Technologies H3C S5120 Series Switches User Manual

Page 641

Advertising
background image

1-14

z

When you configure the password for switching user privilege level with the super password

command, the user privilege level is 3 if no user privilege level is specified.

z

The password for switching user privilege level can be displayed in both cipher text and simple text.

You are recommended to adopt the former as the latter is easily cracked.

Modifying command level

All the commands in a view are defaulted to different levels, as shown in

Table 1-3

. The administrator

can modify the command level based on users’ needs to make users of a lower level use commands

with a higher level or improve device security.

Follow these steps to modify the command level:

To do…

Use the command…

Remarks

Enter system view

system-view

Configure the command level in
a specified view

command-privilege level
level view view command

Required

Refer to

Table 1-3

for the

default settings.

You are recommended to use the default command level or modify the command level under the

guidance of professional staff; otherwise, the change of command level may bring inconvenience to

your maintenance and operation, or even potential security problem.

Displaying and Maintaining Basic Configurations

To do…

Use the command…

Remarks

Display information on system
version

display version

Display information on the
system clock

display clock

Display information on terminal
users

display users [ all ]

Display the valid configuration
under current view

display this [ by-linenum ]

Display clipboard information

display clipboard

Display and save statistics the
running status of multiple
modules

display
diagnostic-information

Available in any view

Advertising