Configuring the maximum number of ospf routes, Configuring ospf preference – H3C Technologies H3C SR8800 User Manual
Page 105
89
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3.
Configure a bandwidth
reference value.
bandwidth-reference value
Optional.
The value defaults to 100
Mbps.
Configuring the maximum number of OSPF routes
To configure the maximum number of routes:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3.
Configure the maximum
number of OSPF routes.
maximum-routes { external | inter | intra }
number
Optional
Configuring the maximum number of load-balanced routes
If several equal-cost routes to the same destination are available, you can configure them as
load-balanced routes to improve link utilization.
To configure the maximum number of load-balanced routes:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
3.
Configure the maximum
number of load-balanced
routes.
maximum load-balancing maximum
Optional
Configuring OSPF preference
A router may run multiple routing protocols, and each protocol is assigned a preference. When the
routing protocols find routes to the same destination, the route found by the protocol with the highest
preference is selected as the best route.
To configure OSPF preference:
Step Command
Remarks
1.
Enter system view.
system-view
N/A