H3C Technologies H3C SR8800 - Manual (Page 367)

351
Step Command Remarks
8. Specify an IPv6 prefix list to
filter routing information
imported from an IPv6
peer/peer group.
peer { ipv6-group-name |
ipv6-address } ipv6-prefix
ipv6-prefix-name import
Not specified by default
9. Specify the upper limit of
prefixes allowed to receive
from an IPv6 peer/peer
group.
peer { ipv6-group-name |
ipv6-address } route-limit limit
[ percentage ]
Optional
Unlimited by default
NOTE:
•
Only routes passing the configured filtering can be added into the local IPv6 BGP routing table.
• Members of a peer group can have different inbound route filtering policies.
Configuring IPv6 BGP and IGP route synchronization
By default, upon receiving an IBGP route, an IPv6 BGP router checks the route’s next hop. If the next hop
is reachable, the IPv6 BGP router advertises the route to EBGP peers. If the synchronization feature is
configured, in addition to the reachability check of the next hop, the IPv6 BGP router must find an active
IGP route with the same network segment before it can advertise the route. (Use the display ipv6
routing-table protocol command to display the IGP route state.)
To configure IPv6 BGP and IGP route synchronization:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view. ipv6-family N/A
4. Enable route synchronization between
IPv6 BGP and IGP.
synchronization Not enabled by default
Configuring route dampening
To configure BGP route dampening:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family
view.
ipv6-family N/A
4. Configure IPv6 BGP route
dampening parameters.
dampening [ half-life-reachable
half-life-unreachable reuse suppress ceiling |
route-policy route-policy-name ]*
Optional
Not configured by
default