H3C Technologies H3C SR8800 - Manual (Page 98)

82
To configure OSPF areas:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id router-id
| vpn-instance vpn-instance-name ]
*
N/A
3. Enter area view. area area-id N/A
4. Configure the area as a stub
area.
stub [ no-summary ] Not configured by default.
5. Specify a cost for the default
route advertised to the stub
area. default-cost cost
Optional.
The default setting is 1.
NOTE:
•
Issue the stub command on routers attached to a stub area.
• The default-cost command only takes effect on the ABR of a stub area.
• The backbone area cannot be a (totally) stub area.
• A (totally) stub area cannot have an ASBR because AS external routes cannot be distributed into the stub
area.
• Virtual links cannot transit (totally) stub areas.
Configuring an NSSA area
A stub area cannot redistribute routes. You can configure the area as an NSSA area to allow for route
redistribution by keeping other stub area characteristics.
To configure an NSSA area:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter OSPF view.
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
N/A
3. Enter area view. area area-id N/A
4. Configure the area as an
NSSA area.
nssa [ default-route-advertise |
no-import-route | no-summary |
translate-always |
translator-stability-interval value ]
*
Not configured by default.
5. Specify a cost for the default
route advertised to the
NSSA area. default-cost cost
Optional.
The default setting is1.