H3C Technologies H3C SR8800 - Manual (Page 364)

348
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enable logging of peer
changes globally.
log-peer-change
Optional
Enabled by default
4. Enter IPv6 address family
view.
ipv6-family N/A
5. Enable the state change
logging for an IPv6 peer or
peer group.
peer { ipv6-group-name |
ipv6-address } log-change Optional
Enabled by default
NOTE:
For information about the log-peer-change command, see the chapter “BGP configuration commands.”
Controlling route distribution and reception
The task includes routing information filtering, routing policy application and route dampening.
Configuration prerequisites
Before you configure route distribution and reception control, complete the following tasks
• Enable IPv6 with the ipv6 command in system view.
• Configure IPv6 BGP basic functions.
Configuring IPv6 BGP route redistribution
To configure IPv6 BGP route redistribution:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter BGP view. bgp as-number N/A
3. Enter IPv6 address family view. ipv6-family N/A
4. Enable default route redistribution into
the IPv6 BGP routing table.
default-route imported
Optional
Not enabled by
default
5. Enable route redistribution from
another routing protocol.
import-route protocol [ process-id [ med
med-value | route-policy route-policy-name ]
* ]
Not enabled by
default
NOTE:
If the default-route imported command is not configured, using the import-route command cannot
redistribute any IGP default route.