H3C Technologies H3C SR8800 - Manual (Page 95)

79
Task Remarks
Configuring an NSSA area
Configuring a virtual link
Configuring OSPF
network types
Configuring the OSPF network type for an interface as
broadcast
Optional
Configuring the OSPF network type for an interface as NBMA Optional
Configuring the OSPF network type for an interface as P2MP Optional
Configuring the OSPF network type for an interface as P2P Optional
Configuring OSPF route
control
Configuring OSPF route summarization Optional
Configuring OSPF inbound route filtering Optional
Configuring ABR Type-3 LSA filtering Optional
Configuring an OSPF cost for an interface Optional
Configuring the maximum number of OSPF routes Optional
Configuring the maximum number of load-balanced routes Optional
Configuring OSPF preference Optional
Configuring OSPF route redistribution Optional
Tuning and optimizing
OSPF networks
Configuring OSPF packet timers Optional
Specifying LSA transmission delay Optional
Specifying SPF calculation interval Optional
Specifying the LSA arrival interval Optional
Specifying the LSA generation interval Optional
Disabling interfaces from receiving and sending OSPF
packets
Optional
Configuring stub routers Optional
Configuring OSPF authentication Optional
Adding the interface MTU into DD packets Optional
Configuring the maximum number of external LSAs in LSDB Optional
Enabling compatibility with RFC 1583 Optional
Logging neighbor state changes Optional
Configuring OSPF network management Optional
Enabling message logging Optional
Enabling the advertisement and reception of opaque LSAs Optional
Configuring OSPF to give priority to receiving and processing
hello packets
Optional
Configuring the LSU transmit rate Optional
Enabling OSPF ISPF Optional
Configuring OSPF FRR Optional
Configuring OSPF Configuring the OSPF GR Restarter Optional