H3C Technologies H3C SR8800 - Manual (Page 299)

283
Step Command Remarks
3. Configure a filter policy to
filter incoming routes.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
import
By default, RIPng does not filter
incoming routing information.
4. Configure a filter policy to
filter outgoing routes.
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ protocol [ process-id ] ]
By default, RIPng does not filter
outgoing routing information.
Configuring a priority for RIPng
Any routing protocol has its own protocol priority used for optimal route selection. You can set a priority
for RIPng manually. The smaller the value is, the higher the priority is.
To configure a RIPng priority:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIPng view. ripng [ process-id ] N/A
3. Configure a RIPng priority.
preference [ route-policy
route-policy-name ] preference
Optional.
By default, the RIPng priority is
100.
Configuring RIPng route redistribution
To configure RIPng route redistribution:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter RIPng view. ripng [ process-id ] N/A
3. Configure a default routing
metric for redistributed routes. default cost cost
Optional.
The default metric of redistributed
routes is 0.
4. Redistribute routes from
another routing protocol.
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
By default, no route redistribution
is configured.
Tuning and optimizing the RIPng network
This section describes how to tune and optimize the performance of the RIPng network as well as
applications under special network environments. Before tuning and optimizing the RIPng network,
complete the following tasks:
• Configure a network layer address for each interface.
• Configure the basic RIPng functions.