Displaying and maintaining static routes, Static route configuration examples, Basic static route configuration example – H3C Technologies H3C SR8800 User Manual
Page 29: Network requirements
13
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the source address
of echo packets.
bfd echo-source-ip ip-address
Not configured by default
3.
Configure static route FRR.
ip route-static [ vpn-instance
vpn-instance-name ] fast-reroute
route-policy route-policy-name
Not configured by default
NOTE:
•
Static route FRR takes effect only for static routes that have both the outbound interface and next hop
specified.
•
Do not use FRR and BFD at the same time.
Displaying and maintaining static routes
Task Command
Remarks
Display information of static
routes.
display ip routing-table protocol static [ inactive |
verbose ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view
Delete all the static routes.
delete [ vpn-instance vpn-instance-name ]
static-routes all
Available in
system view
NOTE:
For more information about the display ip routing-table protocol static
[ inactive | verbose ] [ | { begin
| exclude | include }
regular-expression ] command, see the chapter “IP routing basics configuration
commands.”
Static route configuration examples
Basic static route configuration example
Network requirements
The routers’ interfaces and the hosts’ IP addresses and masks are shown in
. Static routes are
required for interconnections between any two hosts.