Configuring ripng route summarization, Advertising a default route, Configuring a ripng route filtering policy – H3C Technologies H3C SR8800 User Manual
Page 298
282
To configure an inbound/outbound additional routing metric:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type interface-number
N/A
3.
Specify an inbound routing
additional metric.
ripng metricin value
Optional
0 by default
4.
Specify an outbound
routing additional metric.
ripng metricout value
Optional
1 by default
Configuring RIPng route summarization
To configure RIPng route summarization:
Step Command
1.
Enter system view.
system-view
2.
Enter interface view.
interface interface-type interface-number
3.
Advertise a summary IPv6 prefix.
ripng summary-address ipv6-address prefix-length
Advertising a default route
To advertise a default route:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface interface-type
interface-number
N/A
3.
Advertise a default route.
ripng default-route { only |
originate } [ cost cost ]
Not advertised by default
NOTE:
With this feature enabled, a default route is advertised through the specified interface regardless of
whether the default route is available in the local IPv6 routing table.
Configuring a RIPng route filtering policy
You can reference a configured IPv6 ACL or prefix list to filter received/advertised routing information.
You can also specify a routing protocol to filter outbound routes redistributed from the protocol.
To configure a RIPng route filtering policy:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIPng view.
ripng [ process-id ]
N/A