H3C Technologies H3C SR8800 - Manual (Page 305)

289
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE23:82F5 on GigabitEthernet1/1/1
Dest 1::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Dest 2::/64,
via FE80::20F:E2FF:FE23:82F5, cost 1, tag 0, A, 2 Sec
Peer FE80::20F:E2FF:FE00:100 on GigabitEthernet1/1/2
Dest 4::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:100, cost 1, tag 0, A, 5 Sec
[RouterA] display ripng 1 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::20F:E2FF:FE00:1235 on GigabitEthernet2/1/1
Dest 1::/64,
via FE80::20F:E2FF:FE00:1235, cost 1, tag 0, A, 2 Sec
Dest 4::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
Dest 5::/64,
via FE80::20F:E2FF:FE00:1235, cost 2, tag 0, A, 2 Sec
Configuring RIPng route redistribution
Network requirements
• Two RIPng processes are running on Router B, which communicates with Router A through RIPng
100 and with Router C through RIPng 200.
• Configure route redistribution on Router B, letting the two RIPng processes redistribute routes from
each other. Set the default cost of redistributed routes from RIPng 200 to 3.
Figure 106 Network diagram
Configuration procedure
1. Configure IPv6 addresses for the interfaces. (Details not shown)
2. Configure RIPng basic functions:
# Enable RIPng 100 on Router A.
<RouterA> system-view
[RouterA] ripng 100