Configuration procedure – H3C Technologies H3C SR8800 User Manual
Page 147
131
Router A
GE 3/1/1
192.168.0.102/24 Router B
GE 3/1/1
192.168.0.100/24
GE 3/1/2
10.1.1.102/24
GE 3/1/2
13.1.1.1/24
Router C
GE 3/1/1
10.1.1.100/24
GE
3/1/2
13.1.1.2/24
Configuration procedure
1.
Configure IP addresses for the interfaces. (Details not shown)
2.
Configure OSPF basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] ospf
[RouterA-ospf-1] area 0
[RouterA-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] network 121.1.1.0 0.0.0.255
[RouterA-ospf-1-area-0.0.0.0] quit
[RouterA-ospf-1] quit
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] ospf cost 2
# Configure Router B.
<RouterB> system-view
[RouterB] ospf
[RouterB-ospf-1] area 0
[RouterB-ospf-1-area-0.0.0.0] network 192.168.0.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] network 13.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] network 120.1.1.0 0.0.0.255
[RouterB-ospf-1-area-0.0.0.0] quit
[RouterB-ospf-1] quit
[RouterB] interface GigabitEthernet 3/1/2
[RouterB-GigabitEthernet3/1/2] ospf cost 2
# Configure Router C.
<RouterC> system-view
[RouterC] ospf
[RouterC-ospf-1] area 0
[RouterC-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] network 13.1.1.0 0.0.0.255
[RouterC-ospf-1-area-0.0.0.0] quit
[RouterC-ospf-1] quit
3.
Configure BFD:
# Enable BFD on Router A and configure BFD parameters.
<RouterA> system-view
[RouterA] bfd session init-mode active
[RouterA] interface GigabitEthernet 3/1/1
[RouterA-GigabitEthernet3/1/1] ospf bfd enable
[RouterA-GigabitEthernet3/1/1] bfd min-transmit-interval 400
[RouterA-GigabitEthernet3/1/1] bfd min-receive-interval 400