Network requirements, Configuration procedure – H3C Technologies H3C SR8800 User Manual
Page 62
46
Configuring an additional metric for a RIP interface
Network requirements
As shown in the following figure:
•
RIPv2 is enabled on all the interfaces of Router A, Router B, Router C, Router D, and Router E.
•
Router A has two links to Router D. The link from Router B to Router D is more stable than that from
Router C to Router D. Configure an additional metric for RIP routes received through GigabitEthernet
3/1/2 on Router A so that Router A prefers the network 1.1.5.0/24 learned from Router B.
Figure 12 Network diagram
Configuration procedure
1.
Configure IP addresses for the interfaces. (Details not shown)
2.
Configure RIP basic functions:
# Configure Router A.
<RouterA> system-view
[RouterA] rip
[RouterA-rip-1] network 1.0.0.0
[RouterA-rip-1] version 2
[RouterA-rip-1] undo summary
[RouterA-rip-1] quit
# Configure Router B.
<RouterB> system-view
[RouterB] rip
[RouterB-rip-1] network 1.0.0.0
[RouterB-rip-1] version 2
[RouterB-rip-1] undo summary
# Configure Router C.
<RouterC> system-view
[RouterB] rip
[RouterC-rip-1] network 1.0.0.0
[RouterC-rip-1] version 2
[RouterC-rip-1] undo summary
# Configure Router D.
<RouterD> system-view
[RouterD] rip
[RouterD-rip-1] network 1.0.0.0
[RouterD-rip-1] version 2
Router B
Router C
Router A
Router D
Router E
GE3/1/1
1.1.1.1/24
GE3/1/1
1.1.1.2/24
GE3/1/2
1.1.2.1/24
GE3/1/1
1.1.2.2/24
GE3/1/2
1.1.3.1/24
GE3/1/2
1.1.4.1/24
GE3/1/2
1.1.3.2/24
GE3/1/1
1.1.4.2/24
GE3/1/3
1.1.5.1/24
GE3/1/2
1.1.5.2/24