Configuring ospfv3 ipsec policies, Network requirements, Configuration procedure – H3C Technologies H3C SR8800 User Manual
Page 342
326
*Nov 5 11:37:43:062 2009 RouterA RM/6/RMDEBUG: OSPFv3 OSPFv3-BFD: Message Type delete
session, Connect Type direct-connect, Src IP Address FE80::20F:FF:FE00:1202, Dst IP
Address FE80::20F:FF:FE00:1200.
# Display the BFD information of Router A. You can see that Router A has removed its neighbor
relationship with Router B and therefore no information is output.
<RouterA> display bfd session
# Display routes to 1200::0/64 on Router A, and you can see that Router A communicates with
Router B through Router C.
<RouterA> display ipv6 routing-table 2001:2::0 64 verbose
Routing Table :
Summary Count : 1
Destination : 2001:4::0 PrefixLength : 64
NextHop : 2001:2::2 Preference : 10
RelayNextHop : :: Tag : 0H
Neighbor : :: ProcessID : 0
Interface : GigabitEthernet3/1/2 Protocol : OSPFv3
State : Invalid Adv Cost : 2
Tunnel ID : 0x0 Label : NULL
Age : 4610sec
Configuring OSPFv3 IPsec policies
Network requirements
As shown in
,
•
Configure OSPFv3 on the routers. The AS is divided into two areas.
•
Configure IPsec policies on the routers to authenticate and encrypt protocol packets.
Figure 114 Network diagram
Configuration procedure
1.
Configure IPv6 addresses for interfaces. (Details not shown)
2.
Configure OSPFv3 basic functions:
# Configure Router A: enable OSPFv3 and configure the Router ID as 1.1.1.1.
<RouterA> system-view
[RouterA] ipv6