Chapter 8. program setup, 1 program setup, 8 - 1 program setup – Honeywell DCP552 Mark II User Manual
Page 136
Chapter 8.
PROGRAM SETUP
8 - 1
Program Setup
Programming is enabled in the normal display mode. When the
DCP552
is not in the normal mode display, press
the
DISP key
to invoke it. Programming is simpler if you set down the objectives of the program on a program
work sheet before you start programming.
NOTE
For ease of use, please enlarge the copy of the
DCP551/552 Program Work
Sheet
located after page 12-18.
■
Selecting number of program to operate
Numbers can be selected in one of two ways.
•
before programming
•
during programming
●
Selecting program number before programming
Press the
PROG key
in the normal display mode in the READY mode. When the
program number starts flashing, use the
PROG key
or the
↑, ↓, ←, or →
key
to
select a number.
Handling Precautions
Program numbers cannot be selected during external switch input.
See “Section 6-3 Selecting Programs” (page 6-11) for details.
●
Selecting program number during programming
Press the
FUNC
and
PROG keys
in program setting state so that the program
number starts to flash. Use the
↑, ↓, ←, or →
key
to make the desired changes
and press the
ENTER key
to enter them. Note, however, that you must after
exiting the registration state (when set values flash) with the
ENTER key
, press
the
FUNC
and
PROG keys
. When programs are selected in this way, the pattern
items are displayed on the programming map.
This allows you to select a program number of a program other than the one
processed in the RUN mode. It also allows you to select the number of another
program using the external switches.
■
Selecting channel of program to operate
Channels can be selected in one of two ways.
• before programming
• during programming
●
Selecting channel before programming
Press the
FUNC
and
DISP keys
in the normal display mode to change channels.
●
Selecting channel during programming
Press the
FUNC
and
DISP keys
in the program setting mode, to change
channels. The system is set to the program setting mode for a different channel
with the same program number and the pattern item in the first segment is
displayed.
8-1