Honeywell DCP552 Mark II - Manual (Page 165)

9 - 3 Load Procedures
9-6
Insert a memory card when the DCP552 is in the READY mode and the normal display mode, and variable
parameter PA05 has been set to 0. Press the LOAD key to start a load operation. “ CArd ” is displayed in display
panel 1 and “ LOAd ” is displayed in display panel 2. An error code appears if something should go wrong during
the save operation.
■ Load menu
When the LOAD key is pressed in the normal display mode, the load menu panel
is displayed. Use the ENTER key to select the desired menu.
Press the ENTER key to display the desired menu in the message display panel.
The DISP key returns you to the normal display mode.
Note, however, that an autoload operation is performed when the LOAD key is
pressed and variable parameter PA05 is set to 1.
For details, see “Section 9-4 Autoload” (page 9-10) .
A RAM memory card whose internal batteries are too low, cause a card battery
alarm panel to be displayed before the Load menu panel is displayed.
Normal display mode
Load individual programs
LOAD key
ENTER key L o a d C a r d - - - > D C P
P r o g r a m ? ■ Procedures for loading single programs (page 9-7)
Load all programs
↓ key
↓ key
L o a d C a r d - - - > D C P
A l l P r o g r a m s ?
ENTER key
■ Procedures for loading all programs (page 9-8)
Load setup data
↓ key
L o a d C a r d - - - > D C P
S E T U P D a t a ?
ENTER key
■ Procedures for loading setup data (page 9-8)
Load variable parameters
↓ key
L o a d C a r d - - - > D C P
P A R A D a t a ?
ENTER key
■ Procedures for loading variable parameters (page 9-8)
Load PID parameters
↓ key
L o a d C a r d - - - > D C P
P I D D a t a ?
ENTER key
■ Procedures for loading PID parameters (page 9-8)
(including fixed command control data)
Load event configuration data
↓ key
L o a d C a r d - - - > D C P
E V E N T D a t a ?
ENTER key
■ Procedures for loading event configuration data (page 9-9)
Load all parameters
↓ key
L o a d C a r d - - - > D C P
A l l P a r a m e t e r s ?
ENTER key
■ Procedures for loading all parameters (page 9-9)
↓ key
DISP key
↑ key
↑ key
↑ key
↑ key
↑ key
↑ key
↑ key
↑ key
Chapter 9. MEMORY CARD OPERATIONS