Powerware 9315s - Manual (Page 126)

13--4 Powerware 9315 Parallel Capacity/Redundant System with PHP SSBM
164201373 Rev. A 092402
13.4 Configuring the Serial Ports
You must configure the port for communications using the LCD screen and
pushbuttons on the SSBM Monitor Panel.
Select Port 1 or Port 2 from the Setup menu to display one of the Setup Port
screens. The screens for Port 1 and Port 2 are identical, and allow you to specify
settings for the two serial communication ports. Figure 13---3 shows the Setup
Serial Port 1 screen.
Statistics Graphics Setup
Setup
Port 1
Uninterruptible Power System
UPS System Normal
Events Meters
Setup Serial Port 1
Rate
9600
Data/Stop
8 1
Handshaking
XON / XOFF
Save
NO
Time
Mode
TERMINAL
Port 2
Battery
100%
Percent
ALARM: NONE
NOTICES: NONE
15 JUL 1998 09:25:42
Figure 13---3. Setup Serial Port 1 Screen
A small return arrow ( ) appears in the upper right corner of the Setup Port
screen. This arrow is a reminder that you can press the pushbutton on the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area.
If the scroll bar is in the menu box, press the
pushbutton to toggle to the
information area. The first setting (Mode) is highlighted. Press the or
pushbutton to move the highlight to the setting you want to change. To scroll
through the available options for that setting, press the or pushbutton.
To save the settings upon exit from this screen, be sure the Save field is set to YES.