Powerware 9315s User Manual
Page 174
DESCRIPTION:
DRAWING NO:
SHEET:
SSBM CUSTOMER INTERFACE PANEL
6 of 6
164201373---4
A---18
Powerware 9315 Parallel Capacity/Redundant System with PHP SSBM
164201373 Rev. A
092402
Table J. Customer Interface Panel Inputs and Outputs (Cont’d)
Terminal
Block
TB Pin #
Name
Description
1
ON UPS
Contacts used to indicate On UPS status of
2
ON UPS RTN
Contacts used to indicate On UPS status of
Parallel Capacity/Redundant System
3
ON BYPASS
Contacts used to indicate On Bypass status of
4
ON BYPASS RTN
Contacts used to indicate On Bypass status of
Parallel Capacity/Redundant System (See Note 6)
TB4
5
RELAY # 1 NC
G
l
NO
d NC l
TB4
6
RELAY # 1 NO
General purpose NO and NC relay
contacts (See Note 4)
7
RELAY # 1 RTN
contacts. (See Note 4)
8
RELAY # 2 NC
G
l
NO
d NC l
9
RELAY # 2 NO
General purpose NO and NC relay
contacts (See Note 5)
10
RELAY # 2 RTN
contacts. (See Note 5)
1
Bypass ∅ A
2
Bypass ∅ B
3
Bypass ∅ C
Sync Reference Voltage for Optional Powerware
4
Sync Reference ∅ A
Sync Reference Voltage for Optional Powerware
9315 Sync Control Connections.
TB6
5
Sync Reference ∅ B
9315 Sync Control Connections.
Al
d f O i
l P
H Ti C
l
6
Sync Reference ∅ C
Also used for Optional Powerware Hot-Tie Control
and Hot Tie with Sync Control connections
7
Output ∅ A
and Hot-Tie with Sync Control connections.
8
Output ∅ B
9
Output ∅ C
1
+12VDC
2
+12VDC RTN
3
+12VDC
4
+12VDC RTN
TB7
5
+12VDC
Optional CAN Power Supply Panel (A13) Terminal
Block for Powerware 9315 (500 kVA 750 kVA)
TB7
6
+12VDC RTN
Block for Powerware 9315 (500 kVA---750 kVA)
Models only
7
+12VDC
Models only
8
+12VDC RTN
9
+12VDC
10
+12VDC RTN
NOTES:
5.
Relay 1 is normally deenergized and is only energized for an alarm condition.
6.
Relay 2 is normally energized and is only deenergized for an alarm condition.
7.
If the SSBM is setup for a Powerware Sync Control, the ON BYPASS contact is used for Sync
Control and is not available for customer use.