Powerware 9315s - Manual (Page 89)

9--13 Powerware 9315 Parallel Capacity/Redundant System with PHP SSBM
164201373 Rev. A 092402
9.6.9 Port Setup Screen
Select Port 1 or Port 2 from the Setup menu to display one of the Port Setup
screens. The Port Setup screens allow you to specify settings for the two serial
communication ports on the UPS. Figure 9---11 shows the Setup Serial Port 1
screen.
Statistics Graphics Setup
Setup
Port 1
Uninterruptible Power System
UPS System Normal
Alarm:
None
Notice: None
Events Meters
Setup Serial Port 1
RATE
9600
DATA/STOP
8 1
HANDSHAKING
XON / XOFF
SAVE
NO
Time
MODE
TERMINAL
Port 2
48.5
Minutes
Battery
15 NOV 1997 09:25:45
Language
Figure 9---11. Port Setup Screen
The small return arrow ( ) appears in the upper right corner of the Port Setup
screen. This arrow is a reminder that you can press the pushbutton on the
Monitor Panel to toggle the pushbuttons between the menu box and the
information area. When the scroll bar is in the information area, the return arrow is
in the menu box. When the scroll bar is in the menu box, the return arrow is in the
information area.
When the scroll bar appears in the information area, you can use the pushbuttons
to change the port configuration. To change a setting, press the and pushbuttons
to move the highlight to the setting you want to change. To scroll through the
available options for that setting, press the or pushbutton. To save the
settings upon exit from this screen, be sure the SAVE field is set to YES.
The setup screens for Port 1 and Port 2 are identical. For detailed information
about configuring the serial ports, refer to Chapter 13, “Serial Communications.”