Nortel Networks 5500 series - Manual (Page 101)

Configuring the domain 101
/cfg/domain #/server/trace
followed by:
You can read a saved TCP traffic dump file
using the TCPDUMP or Ethereal application on
a remote machine.
The default output mode is interactive .
ping <host> Verifies station-to-station connectivity across
the network.
•
host is the host name or IP address of the
target station
If a backend interface is mapped to the current
Nortel SNAS domain, the check is made
through the backend interface. To map a
backend interface to the domain, use the
/cfg/domain #/adv/interface command
(see “Configuring advanced settings” (page
109) ).
To be able to use a host name, the DNS
parameters must be configured (see
“Configuring DNS servers and settings” (page
276)
).
dnslookup <host> Finds the IP address for a machine whose
host name you specify, or the host name of a
machine whose IP address you specify.
•
host is the host name or IP address of the
machine
If a backend interface is mapped to the current
Nortel SNAS domain, the check is made
through the backend interface. To map a
backend interface to the domain, use the
/cfg/domain #/adv/interface command
(see “Configuring advanced settings” (page
109) ).
traceroute <host> Identifies the route used for station-to-station
connectivity across the network.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.