Nortel Networks 5500 series User Manual
Page 44
44
Initial setup
Alteon iSD NSNAS
Hardware platform:
4050
Software version:
x.x
---------------------------------------------------
----
[Setup Menu]
join - Join an existing cluster
new - Initialize host as a new installation
boot - Boot menu
info - Information menu
exit - Exit [global command, always available]
>> Setup#
2
Select the option for a new installation.
>> Setup# new
Setup will guide you through the initial configuration.
3
Specify the management interface port number. This port will be
assigned to Interface 1.
Enter port number for the management interface [1-4]:
<port>
In an one-armed configuration, you are specifying the port you
want to use for all network connectivity, since Interface 1 is used
for both management traffic (Nortel SNAS management and
connections to intranet resources) and client portal traffic (traffic
between the Nortel Health Agent applet on the client and the
portal).
4
Specify the RIP for this device. This IP address will be assigned
to Interface 1.
Enter IP address for this machine (on management
interface): <IPaddr>
The RIP must be unique on the network and must be within the
same subnet as the MIP.
5
Specify the network mask for the RIP on Interface 1.
Enter network mask [255.255.255.0]: <mask>
6
If the core router attaches VLAN tag IDs to incoming packets,
specify the VLAN tag ID used.
Enter VLAN tag id (or zero for no VLAN) [0]:
If you do not specify a VLAN tag id (in other words, you accept
the default value of zero), the traffic will not be VLAN tagged.
When configuring the network access devices in Layer 2
configurations, ensure that you add the uplink ports to the Nortel
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100
03.01
Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.