Nortel Networks 5500 series - Manual (Page 456)

456 Syslog messages
About event messages
Events are sent at the NOTICE syslog level. Event messages are
formatted according to the following pattern:
Name: <Name>
Sender: <Sender>
Extra: <Extra>
Table 78 "System Control Process messages—EVENT" (page 456) lists
the System Control Process EVENT messages.
Table 78
System Control Process messages—EVENT
Message Category Explanation/Action
Name: partitioned_network
Sender and Extra is lower level
information. EVENT Indicates that a Nortel SNAS is
recovering from a partitioned network
situation.
Name: ssi_mipishere
Sender: ssi
Extra: <IP> EVENT Indicates that the Management IP
address (MIP) is now located at the
Nortel SNAS with the <IP> host IP
address.
Name: software_configuration_chang
ed
Sender: system
Extra: software release version
<VSN> <Status> EVENT Indicates that release <VSN>
(version) software status is <Status>
(unpacked/installed/permanent).
Name: software_release_copying
Sender: <IP>
Extra: copy software release <VSN>
from other cluster member EVENT Indicates that <IP> is copying the
release <VSN> from another cluster
member.
Name: software_release_rebooting
Sender: <IP>
Extra: reboot with release version
<VSN> EVENT Indicates that a Nortel SNAS (<IP>) is
rebooting on a new release (in other
words, a Nortel SNAS that was not
up and running during the normal
installation is now catching up).
Name: audit
Sender: CLI
Extra: Start <session> <details>
Update <session> <details> Stop
<session> <details> EVENT Sent when a CLI system administrator
enters, exits, or updates the CLI
if audit logging is enabled using
the
/cfg/sys/adm/audit/ena
command.
Name: license_expired
Sender = <IP> EVENT Indicates that the demo license
loaded to host <IP> has expired.
Check the loaded licenses with
/cfg/sys/cur .
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.