Nortel Networks 5500 series User Manual

Page 370

Advertising
background image

370

Upgrading or reinstalling the software

marked as unpacked. After you activate the unpacked software version
(which causes the Nortel SNAS to reboot), the software version is marked
as permanent. The software version previously marked as permanent will
then be marked as old.

For minor and major releases, the software upgrade occurs in
synchronized fashion among the set of Nortel SNAS devices in a cluster. If
a Nortel SNAS device in a cluster is not operational when the software is
upgraded, it will automatically pick up the new version when it is started.

ATTENTION

If more than one software upgrade has been performed on a cluster while a
Nortel SNAS device has been out of operation, the software version currently in
use in that cluster must be reinstalled on that Nortel SNAS device. For more
information about how to perform a reinstall, see

“Reinstalling the software”

(page 372)

.

When you have downloaded the software upgrade package, you can
inspect its status with the

/boot/software/cur

command.

Step

Action

1

At the

Software Management#

prompt, enter the following

command:

>> Software Management# cur

Version

Name

Status

-------

----

------

x.x

NSNAS

old

z.z

NSNAS

permanent

The downloaded software upgrade package is indicated with the
status

unpacked

. The software versions can be marked with

one out of four possible status values. The meaning of these
status values are:

unpacked

means that the software upgrade package has

been downloaded and automatically decompressed.

permanent

means that the software is operational and will

survive a reboot of the system.

old

means the software version has been permanent but is

not currently operational. If a software version marked old
is available, it is possible to switch back to this version by
activating it again.

current

means that a software version marked as old or

unpacked has been activated. As soon as the system has

Nortel Secure Network Access Switch

Using the Command Line Interface

NN47230-100

03.01

Standard

28 July 2008

Copyright © 2007, 2008 Nortel Networks

.

Advertising
This manual is related to the following products: