Nortel Networks 5500 series - Manual (Page 164)

164 Configuring groups and profiles
Figure 6 "Client Filter menu commands" (page 164) shows sample output
for the /cfg/doamin #/aaa/filter <filter ID> command and
commands on the Client Filter menu.
Figure 6
Client Filter menu commands
Configuring extended profiles
To create and configure an extended profile, use the following command:
/cfg/doamin #/aaa/group <group ID | group name> /extend
[<profile ID>]
where
profile ID is an integer in the range 1 to 63 that
uniquely identifies the profile in the group.
If you do not enter the profile ID as part of the
command, you are prompted to do so.
When you first create the extended profile, you must enter the profile ID.
After you have created the extended profile, you can use either the profile
ID or the name of the associated client filter to access the extended profile
for configuration.
When you first create the profile, you are prompted to enter the following
parameters:
• client filter name—the name of the predefined client filter that
determines whether the Nortel SNAS will apply this extended profile to
the user. To view available filters, press TAB at the prompt. You can
later change the filter referenced by the profile by using the
filter
command on the Extended Profile menu.
•
VLAN—the name of the VLAN to which the Nortel SNAS will assign
users with this profile. You can later change the VLAN assignment
for the profile by using the
vlan command on the Extended Profile
menu.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.