Nortel Networks 5500 series - Manual (Page 327)

Configuring SNMP 327
/cfg/sys/adm/snmp/snmpv2-mib
followed by:
sysContact <contact> Designates a contact person for the
managed Nortel SNAS cluster.
•
contact is a string specifying the
designated contact person’s name,
together with information about how to
contact this person.
snmpEnable disabled|enabl
ed
Enables or disables generating
authentication failure traps. The default is
disabled.
Configuring the SNMP community
To configure the community aspects of SNMP monitoring, use the
following command:
/cfg/sys/adm/snmp/community
The SNMP Community menu appears.
The SNMP Community menu includes the following options:
/cfg/sys/adm/snmp/community
followed by:
read <name> Specifies the monitor community name
that grants read access to the MIB. If you
do not specify a monitor community name,
read access is not granted.
The default monitor community name is
public .
write <name> Specifies the control community name that
grants read and write access to the MIB.
If you do not specify a control community
name, neither read nor write access is
granted.
trap <name> Specifies the trap community name that
accompanies trap messages sent to the
SNMP manager. If you do not specify a
trap community name, the sending of trap
messages is disabled.
The default trap community name is trap .
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.