Nortel Networks 5500 series - Manual (Page 75)

Configuring SNMP Profiles 75
Nortel ES 325, 425, 450, 460, BPS, 470, and ERS 2500, 4500, 5500,
8300, and 8600. In addition, SSCPLite supports Cisco 2900, 3500, and
3700 series Ethernet switches.
• SSCPLite uses the SNMP Protocol
•
Switches does not support Dynamic Host Control Protocol
•
Switches may not support the DHCP signature based identification for
VOIP phones
• Nortel SNAS should use MAC Authentication
• Multiple PCs connected using hub to the switch port are not supported.
To configure the sscplite, access the menu by using the following
command.
cfg/domain #/switch #/mgmtproto
Configuration of switch menu are modified to include different
communication protocols (sscp, sscplite). SSCP is selected by default.
Usage: mgmtproto <sscp/sscplite>
SSCP SSCPLite
The sscplite includes the following option:
/cfg/domain #/switch #/sscplite
followed by:
profile Set SNMP profile to use
Configuring SNMP Profiles
To configure the snmp profiles, use the following command:
cfg/domain #/snmp-profile
Enter the SNMP profile number. Creates the SNMP profile #.
Enter the name of this SNMP profile.
Enter the version supported for the SNMP profile. Values are v1, v2c, and
v3.
Enter the SNMP port to communicate.
Enter the data refresh interval in seconds.
Enter the CLI user name.
Enter the CLI user password.
Reconfirm the password.
Enter the CLI login type. Values are ssh and telnet.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.