Nortel Networks 5500 series - Manual (Page 279)

Configuring the cluster 279
Configuring RSA servers
To configure the symbolic name for the RSA server and import the
sdconf.rec configuration file, use the following command:
/cfg/sys/rsa
The RSA Servers menu appears.
ATTENTION
This feature is not supported in Nortel Secure Network Access Switch Software
Release 1.6.1.
The RSA Servers menu includes the following options:
/cfg/sys/rsa
followed by:
rsaname <name> Sets the symbolic name of the RSA server.
import <protocol>
<server> <filename>
[ <FTP user name> <FTP
password> ]
Imports a copy of the sdconf.rec file from
the specified TFTP/FTP/SCP/SFTP server.
•
protocol is the import protocol. Options
are tftp|ftp|scp|sftp .
•
server is the host name or IP address of
the server.
•
filename is the name of the sdconf.rec
file on the server.
The sdconf.rec file is a configuration file that
contains critical RSA ACE/Server information.
Contact your RSA ACE/Server administrator
to obtain the file and make it available on the
specified TFTP/FTP/SCP/SFTP server.
rmnodesecr Removes the RSA node secret, if necessary.
Authentication will then fail until the Node
secret created check box is unchecked in the
Edit Agent Host window on the RSA server.
del Deletes the current RSA server information.
Configuring syslog servers
The Nortel SNAS software can send log messages to specified syslog
hosts.
For descriptions of the log messages that the Nortel SNAS can send to a
syslog host, see
“Syslog messages” (page 451) .
To configure syslog servers for the cluster, use the following command:
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.