Nortel Networks 5500 series - Manual (Page 26)

26 Overview
— Nortel IP Phone 2002
— Nortel IP Phone 2004
— Nortel IP Phone 2007
See Release Notes for the Nortel Secure Network Access Solution,
Software Release 1.6.1 (NN47230-400), for the minimum firmware
versions required for the IP Phones operating with different call
servers.
Each Nortel SNAS -enabled port on a network access devices can support
one PC (untagged traffic) and one IP Phone (tagged traffic). Softphone
traffic is considered to be the same as PC traffic (untagged).
ATTENTION
Where there is both an IP Phone and a PC, the PC must be connected through
the 3-port switch on the IP Phone.
Supporting additional users with the software license file
The standard Nortel SNAS 4050 implementation can support up to 200
authenticated user sessions. To support additional users on your Nortel
SNAS 4050 switch, you must obtain a Nortel SNA software license
file. The software license file contains a software license key that you
must enter into the Nortel SNAS 4050 switch to activate support for the
additional users. The file can support an additional 100, 250, 500, or 1000
users.
ATTENTION
An authenticated IP Phone is considered to be a licensed user.
Your unique software license key is based on your switch MAC address.
Before you obtain your software license file, first record the MAC address
for the Nortel Secure Network Access Switch to be upgraded. To find the
MAC address in the Command Line Interface, use the
/info/local
command.
To obtain your software license file, contact Nortel to order the Nortel SNA
Software License Certificate. Follow the instructions on this certificate to
obtain your software license file.
After you obtain the software license file from Nortel, you must copy
the entire license key to the switch using the CLI or the BBI. When you
copy the license key, ensure you include the
BEGIN LICENSE and END
LICENSE lines.
To copy the license key using the CLI, use the following command:
/cfg/sys/host <host ID> license <key>
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.