Nortel Networks 5500 series User Manual
Page 65
Managing network access devices
65
To configure a network access devices in the Nortel SNAS domain, use
the following command:
/cfg/domain #/switch <switch ID>
where
switch ID
is the ID or name of the switch you want to
configure.
The Switch menu appears.
The Switch menu includes the following options:
/cfg/domain #/switch <switch ID>
followed by:
name <name>
Names or renames the switch. After you have
defined a name for the switch, you can use
either the switch name or the switch ID to
access the Switch menu.
•
name
is a string that must be unique in the
domain. The maximum length of the string
is 255 characters.
type ERS8300|ERS5500
Specifies the type of network access devices.
Valid options are:
•
ERS8300
—an Ethernet Routing Switch
8300
•
ERS5500
—an Ethernet Routing Switch
5510, 5520, or 5530
The default is
ERS8300
.
mgmtproto<mgmtproto>
Sets the Switch Management Protocol.
ip <IPaddr>
Specifies the IP address of the switch.
port <port>
Specifies the TCP port used for Nortel SNAS
communication. The default is port 5000.
hlthchk
Accesses the Healthcheck menu, in order
to configure settings for the Nortel SNAS
to monitor the health of the switch (see
“Monitoring switch health” (page 73)
vlan
Accesses the Switch Vlan menu, in order to
map the Green and Yellow VLANs configured
on switch (see
).
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100
03.01
Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.