Nortel Networks 5500 series - Manual (Page 499)

Configuring IP Phone auto-configuration 499
Table 94
Call Server Information string parameter values (cont’d.)
Parameter Description
aaa The Action for the server
rrr The Retry Count for the server
The DHCP Option #128 pertains to the Call Server
information that the IP Phone will need in order to connect
to the call server.
The following rules apply:
• The IP Address must be separated from the port by a
colon (:).
•
The parameters for the Primary (S1) and Secondary (S2)
are separated by a semicolon (;).
•
The string must end in a period (.)
ATTENTION
After you have entered the string, it will subsequently appear
automatically each time the option is added to a scope.
c Click Apply.
5 Configure VLAN Information:
a In the Scope Options dialog box (see Figure 36 "The
Scope Options dialog box" (page 498) ), select 191 VLAN
Information.
b In the String value field, enter the following string:
VLAN-A:vvvv.
Table 95 "VLAN ID Information string parameter values"
(page 499)
describes the parameters.
Table 95
VLAN ID Information string parameter values
Parameter Description
A The hardware revision of the IP
Phone
vvvv The VLAN ID in decimal
The site-specific option #191 pertains to the VLAN ID
information that the IP Phone will require in order to boot into
the Phone VLAN.
The following rules apply:
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.