Nortel Networks 5500 series - Manual (Page 393)

Steps 393
Use the applicable show commands on the router to verify that
DHCP relay has been activated to reach the correct scope for
each VLAN.
--End--
Configure the Ethernet Routing Switch 8300
The configuration procedure is based on the following assumptions:
• You are starting with an installed switch that is not currently configured
as part of the network.
•
You have installed Software Release 2.2.8.
•
You have configured basic switch connectivity.
• You have initialized the switch and it is ready to accept configuration.
• You have configured devices as described to this point.
Steps
To configure the Ethernet Routing Switch 8300for the Nortel SNAS
network, perform the following steps:
1. “Enabling SSH” (page 393)
2. “Configuring the Nortel SNAS pVIP subnet” (page 394)
3. “Creating port-based VLANs” (page 394)
4. “Configuring the VoIP VLANs” (page 394)
5. “Configuring the Red, Yellow, and Green VLANs” (page 394)
6. “Configuring the NSNA uplink filter” (page 394)
7. “Configuring the NSNA ports” (page 394)
8. “Enabling NSNA globally” (page 395)
Enabling SSH
Passport-8310:5# config bootconfig flags ssh true
Passport-8310:5# config sys set ssh enable true
Passport-8310:5# config load-module 3DES /flash/P83C2280.
IMG
ATTENTION
You have the option of using the AES encryption module, instead of the 3DES
module.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.